Model Boat Mayhem

The Shipyard ( Dry Dock ): Builds & Questions => Working Vessels => Topic started by: timgarrod on September 03, 2016, 02:44:39 pm

Title: Robbe Norderney
Post by: timgarrod on September 03, 2016, 02:44:39 pm
Couldn't belive my luck but been looking for one of these for some time and this turned up on ebay under door and hinges  selection {-)

they person said it was built 30 years ago and looks like new. just need to replace the prop and rudder on the mowe. does any know the size if prop needed.

now to figure out how to wire it up to my f16 transmitter. crane will take up both the 3 position switch on the add module the others are just on/off, but not sure which chanel to use for the anchor. as the two sticks will be for the boats.

its got the orginal robbe gearboxes but motors say 6-8 volt. but think they will handle 12v fine. if its any thing like the bermpohl it going to be fun to recover the mowe  :} .
Title: Re: Robbe Norderney
Post by: timgarrod on September 05, 2016, 06:58:33 pm
been looking at the mowe today and the lid and hull was attached by a elastic band. is this correct as seams bit risky when lifting it up by the crane