Model Boat Mayhem
Technical, Techniques, Hints, and Tips => The "Black Arts!" ( Electrics & Electronics ) => Topic started by: The Old Fart on September 15, 2017, 09:07:04 pm
-
I found these on Ebay,
tried one and ordered 5 more.
Self priming and low current.
http://www.ebay.co.uk/itm/DC-12V-High-Flow-Low-Noise-Hot-Water-Pump-Diaphragm-Pump-Self-priming-Pump/131985035863?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
-
Looks good. I have found that a lot of the small pumps on e-bay are intended for submerged operation (aquariums etc.) and so don't need to worry about a small leak when operating. That is annoying if you run the pump inside a boat. Have you had any drips or dribbles from this one?
Greg
-
So far so good.
Printed holder that sits across stern hull, pump clips out if needed.
-
Looks good mate, even if it does leak, it will pump itself out