Model Boat Mayhem
Mess Deck: General Section => Full Scale Ships => Topic started by: merseyferry on October 11, 2017, 12:39:18 pm
-
hello i an still rebuilding calypso and i have not got the build manual, my question is when fitting the hulls obsevation chamber , do i cut into the hull to fit the chamber, or cut the chamber to fit hull pic 1 is bottom of hull were chamber goes pic 2 is the obsevation chamber still on plastic card best regards pat '....... ps if any one needs any lost parts for calypso i might be able to help
-
Not actually built one but a model I have looked at closely over last few years and I was lead to believe it was stuck around it, I don't think you have to cut the hull? and I would think if you did it would leave a weak spot on the hull as the slightest bump up front could dislodge it
but that is only my opinion, hope you find out a definitive answer
Cheers
Paul
-
You can find a build manual on Manuall.co.uk
Regards
-
thank you for your reply gents(paul,terry) ive down loaded the plans and will paint before i fit to hull best regards pat