Model Boat Mayhem

Mess Deck: General Section => Chit-Chat => Topic started by: barriew on October 22, 2017, 01:16:01 pm

Title: Billings Norden - anyone fitted RC?
Post by: barriew on October 22, 2017, 01:16:01 pm
I've just acquired a Billing's Norden kit and wondered if anyone had fitted RC to one. It looks as though it will require quite a bit of butchery to do so %) .
 I believe that S T Canute uses a similar construction technique i.e  hull built in two halves, so if anyone has added RC to one of those I would be interested.


Barrie
Title: Re: Billings Norden - anyone fitted RC?
Post by: timg on October 22, 2017, 10:29:30 pm
Hi Barrie


I have built a st canute and fitted r/c  , your right about the hull been built In  two halves, the hull is around 56cm but the norden looks around 35 cm which will be a lot more challenging.
Nice looking model if you can do it
Good luck
Spud