Model Boat Mayhem
Technical, Techniques, Hints, and Tips => Detail Work, Rigging, Fittings, Figures Etc. => Topic started by: The Old Fart on May 31, 2018, 08:08:16 pm
-
I need to drill some brass castings, but they are very hard, any ideas?
-
I use cobalt tipped drills which seem to go through anything. They are not to expensive either and last a lot longer than jobber drill bits
-
Thank you, I'll order some.
-
Cobalt drill bit worked a treat, and they weren't too expensive.
-
That’s great news :-)) try them in a bit of stainless steel they’re fantastic!