Model Boat Mayhem - Forum

Dry Dock / Shipyard: Builds & Questions => Springer Tugs => Topic started by: Gardener on October 05, 2018, 03:06:33 PM

Title: Ply
Post by: Gardener on October 05, 2018, 03:06:33 PM
just ordered some ply from Slec to start on a Springer Tug, my first build project from scratch ...
Title: Re: Ply
Post by: nemesis on October 08, 2018, 04:18:08 PM
Hi, Select the best side. There is always a good side, then grain fill and "sand and seal" the sheet or piece that you are going to use. It is much easier to do it on the flat rather than when the object is constructed. Got the T shirt. if you know all this I am truly sorry. nemesis
Title: Re: Ply
Post by: Gardener on October 08, 2018, 05:48:10 PM
Thanks  :-))