Model Boat Mayhem
Technical, Techniques, Hints, and Tips => Engineering Techniques and Materials. => Topic started by: Trucker on May 22, 2020, 03:17:50 pm
-
Hi gentleman
Would it be beneficial to put some heat on to 2 mm aluminum tube before bending, I intend to squeeze flat each end before drilling but the flat part requires a step shape to fit my requirements.
Trucker
-
Hi, Rub the area where the bend is going to be with soap. apply heat eg gas torch, until the soap turns brown, let it cool and you have a small window to do the task. if it takes longer to do the job do the annealing again. Nemesis
-
Hi, nemesis
Thanks for you advise, I will give it a go and reply back in a couple if days,
-
Hi, Nemesis
The annealing and bending of my aluminum went well, thanks for your help,
Trucker
-
you are welcome, thank you. nemesis
-
I have in the past filled a brass tube with water then freezed it in the freezer then made the bend