Model Boat Mayhem

Mess Deck: General Section => Chit-Chat => Topic started by: colin-stevens on July 13, 2006, 09:59:09 pm

Title: korz nozzle
Post by: colin-stevens on July 13, 2006, 09:59:09 pm
Hi, can you help. I am looking for a nozzle about 65mm tapering to 48mm do x 37mm in length. These are not critical a bit either way on any measurement will be good enough. Any help would be gratefully accepted. was going to spin me own up but turns out the lathe i have acssess to wont spin that big. killed me project stone dead.
 
Thanks in advance
Colin
Title: Re: korz nozzle
Post by: Shipmate60 on July 13, 2006, 10:55:10 pm
Scoonies sell Korts.

Bob
Title: Re: korz nozzle
Post by: DavieTait on July 14, 2006, 12:00:11 am
Well looking in the most recent Scoonies catalogue they list a Nozzle that should suit you.

Page 15 , code number BS ( no not joking !! ) : Kort Nozzle 50mm internal diamere at rear : price : ?11 +p&p
Drop Andy an Email to check this is what your looking for: andy@scoonie-hobbies.co.uk
or they're website : www.scoonie-hobbies.co.uk

Davie
Title: Re: korz nozzle
Post by: norry on July 14, 2006, 12:51:49 am
Mobile Marine Models in Lincoln do a nice range of Kort Nozzles...their number is 01522 730731... or 01522 689209...Tell them Norry sent you...

REGARDS...Norry Mason...
Title: Re: korz nozzle
Post by: colin-stevens on July 15, 2006, 06:56:56 pm
new i could rely on you guys. sent an e-mail of to mobile marine in the week, waiting for a reply. just walloped one of to Skoonies. ordered one from my local shop today, the robbe one at 50mm. lets see. hope it works out.
cheers onsa and all

colin