Hi
All
I promise to put some pictures up soon - The first hull is out of the mould and i'm now working on the deck moulding.This will allow the whole deck to be lifted off instead of just the superstructure as is the norm,i'm planning on having the deck fitting into a flange that runs around the deck with a rubber seal and m4 stainless countersunk machine screws to hold it down securley (heads painted to match the deck).
Once this is done i'll start on the bridge moulding-should be fun with the angles on the modern tugs!,The drive units will be the smaller graupner ones as the models only 2ft long but haven't decided on the motors yet so any advice welcome?
cheers