Couple more pics which include Bitannia. Am starting to do the rigging and one part is of stainless wire which I have found to be a bit awkward for two reasons; first, getting and then keeping it straight and secondly, because of the tension required to then keep it straight, I then needed to make sure the wire is pulled down tightly. For this I have used some pins which have a hole in to hold a ring. The pin I grooved to hold cyno before quickly but lightly hammering down, (will get close-up photo next time) after drilling a smaller sized hole in deck. The windlass and the other black bit - cant always remember the names of the parts!! I had to make myself as supplied parts were c##p.
Other boats are the President by Amati, the Will thames barque by Billings and a paddle boat (still to be finished).
Because I am a relative newcomer to this site, I have not got many pics from when I started these. I will try to find any though as I think I have a few somewhere in this computer.
Ron.