Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: motor cooling coils  (Read 1609 times)

ando

  • Guest
motor cooling coils
« on: August 05, 2008, 12:20:06 am »

hi i am quite new to this hobbie
                           i know that the inlet tube sit,s behind the prop  and then on to the coil but were is the best position to site the outlet tube ( fitting )   ????
                             If two motor used  !!  yes i know inlet near prop !!   but do i need to site both outlet tubes ( fittings ) together ???
     Regards     Ando
Logged

andyn

  • Guest
Re: motor cooling coils
« Reply #1 on: August 05, 2008, 12:33:04 am »

On a single motor setup, you go straight out the side of the boat, 90 degrees to the motor, With two motors, you can either go for two outlets, one either side  of the boat, or both outlets on one side of the boat, again, straight out from the motors
Logged

ando

  • Guest
Re: motor cooling coils
« Reply #2 on: August 08, 2008, 08:42:18 pm »

hello     thanks for the info  O0 :)
Logged
Pages: [1]   Go Up
 

Page created in 0.086 seconds with 20 queries.