Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Adolph Bermphol  (Read 2012 times)

lucifer

  • Guest
Adolph Bermphol
« on: November 11, 2008, 11:51:59 am »

Ok so I've been making some good progress on my Adolph Bermphol and I've hit a snag my soldering skills are next to useless when it comes to making the rails and superglue just isn't up to the challenge

So my question is does anyone know where I could get 55mm > 60mm 2 hole stanchions or would I be best just to try brass rod / pipe and drill the holes myself?

I’ll put some pictures of the build so far later  (once I’ve taken some )   O0

Thanks in advance
Jay
Logged

lucifer

  • Guest
Re: Adolph Bermphol
« Reply #1 on: November 12, 2008, 04:39:58 pm »

Basic structure is complete and hull almost ready for float tests also visible is checker plate walk treads



Bow thrusters visible to aide with manoeuvring


Nasty plastic props replaced with nice brass ones 


Basic retrieval system starting to be fitted ( work in progress) but have already fitted a High power servo for the rear door   
Logged

yantoe

  • Guest
Re: Adolph Bermphol
« Reply #2 on: February 17, 2009, 03:27:07 pm »

hi ive just bought a Adolph Bermphol  that needs loads of tlc. if pos can you send photo copys of build plans.(IF NOT TOO GREAT) will pay for them. and any photos of your boat so  i can see whare things go  thanks yantoe
Logged
Pages: [1]   Go Up
 

Page created in 0.098 seconds with 19 queries.