Step one is as usual the stand.
If you do this first then you have a nice platform to support the boat for the rest of the build.
The timber for the stand is roughly cut. It does the job.
It is flimsy, but it does the job.
The straps are very thin, but they do the job.
And they also had a tendancy to slide off the tops of the stand side, so I had to glue as well as screw.
The keel weight is also longer than the stand so you need to twist the boat to get the keel bulb clear of the stand, but it does the job.
The screws are steel, not good near water, but they do the job.
Every cost is shaved back to the minimum, and fingers crossed, it does the job.