Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length.

[Noah]

I recently acquired a Robbe - AKKU 4.8 - 6 volt Minicontroller 2A (with no instructions), & would like to know if anyone out there can tell me how to set it up?
It is currently attached to two small 3 volt motors & powered by 4 AA batteries.
When switched on (TX first) the motors pulse continuously, with no neutral position & the case feels warm to the touch.
I have looked in side the case & found 2 potentiometers, which obviously need adjusting.
I would like to know which one does what & the correct set up sequence.

Noah

[DickyD]

Cant even find it on Robbes web site.

[stallspeed]

There is no processor so no required sequence,Noah.The Robbe MiniController  (PART No. 8297) is as old as........

By trial and error you will find they control span,neutral or deadband.

[Noah]

Thank you for the info, Stallspeed.
I have received a PM from Stan of the Kirklees Model Boat Club, who might have the Destruction Sheet !
Must make time to have a dabble over the weekend, before sailing with Fenland Marine Model Group.

Regards
Noah