Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Advice and help please  (Read 1538 times)

emarald

  • Guest
Advice and help please
« on: July 08, 2009, 05:54:00 pm »

re-doing the bow thruster on my aziz i bought awile ago it's loose and turns up and down over 45 degrees i cant get it out so i have to glue it in sittu but not sure if i can make it water tight by getting the glue all the way round and the space is tight any  body got sugestions on what to glue it with and to make it water tight thanks
Logged

Umi_Ryuzuki

  • Guest
Re: Advice and help please
« Reply #1 on: July 08, 2009, 06:16:11 pm »

Perhaps some 30 or 45 minute epoxy thinned with denatured alcohol.

Mix the epoxy, then thin it till it is thin enough to brush into the area around the
thruster. Rotate the thurster assembly a few times as you do this.
The thinned epoxy should wick its way around and into the contact area
between the thruster tube an hull.

 :-)
Logged

emarald

  • Guest
Re: Advice and help please
« Reply #2 on: July 08, 2009, 11:02:18 pm »

thankyou very much Umi_Ryuzuki  most helpfull will give it ago
Logged
Pages: [1]   Go Up
 

Page created in 0.099 seconds with 19 queries.