I have already glued it back, but that doesn't sound like a bad idea. I'll keep it in mind for my next build(although that might be a while).
Build update:
I wasn't happy with the starboard nozzle setup, so I removed shaft guidance device of it, to make it match the port setup. This was glued back to getter last night. Also glued the bow thruster tubes to getter, so they a are now ready to be attached on the hull.
Then today I measured up where the shaft housings were going to sit and glued them on to getter with the stern running gear. Spent almost an hour watching it all dry, constantly making sure everything lined up.
btw won't have a camera till tomorrow, so until then I can't take any pictures to show you guys.
Also wanted to mention that I think I'm going to use some fiber optics illumination, inspired buy a bourbon orca build I saw, you think this is a good idea?