Hi everyone and a happy new year, I need some help regarding mtronics speed controllers .
I originally had one controller powering a pair of motors not sure what size and thought to get longer run time I could fit another controller and two batteries instead of one 12v 7.5 a h which would then give me independent control of each motor.
Problem one motor runs fine the other stops and starts and I notice the controller reset each time.
I have followed the instructions for the new controller and disconnected the red power lead and also switched controllers with no difference ,and as I have never had a problem with the original mtronics I was wondering has anyone had this problem as I would really like to get this system to work
Cheers from newby
John
Are they Vipers ? what model / amps etc
They will work fine out of the packet with most t/mitters as they are factory pre set... What do you mean that you notice it re set ? you may have altered the neutral and end / brake points.
Do I take it that from the above you are using 2 separate channels for independantly controlling the motors ?. and you have set up each controller and motor independantly ?
if they are Vipers leave each controller switch , switched on and just switch main power on / off and test them as FLJ says and only 1 red wire to the RX as this will power BOTH speedos.
post a pic of the set up wiring etc.
I run this set up in a R/C tank with no issues.
hope its of use
Sub.