Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: T-Cut anyone???  (Read 1054 times)

Mark47

  • Guest
T-Cut anyone???
« on: September 10, 2009, 04:36:02 PM »

Long story short (I did have a full commentary on what has happend to my hull, but the forum seen fit to kick me out and start again).

Has anyone used T-Cut after using Halfords gloss varnish on their hull? I have a couple of runs of varnish that I want to sand back with 1500 wet & dry, then I though T-cut would bring it back finishing with a couple of coats of wax.

I have heard of a few people doing this but I've never seen the final finish.

Mark
Logged

gondolier88

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,351
  • www.coniston-regatta.co.uk
  • Location: Crake Valley, Cumbria
    • Coniston Regatta
Re: T-Cut anyone???
« Reply #1 on: September 10, 2009, 05:10:56 PM »

No reason why not, as long as you have a strong enough elbow- lacquer is a damn sight harder than paint- if it were me i'd find some furniture lacquer burnishing cream.

Greg
Logged
Don't get heated...get steamed up!
Pages: [1]   Go Up