Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: errr... hello and hull help please  (Read 1695 times)

eddie the idiot

  • Guest
errr... hello and hull help please
« on: October 06, 2009, 05:34:57 pm »
I'm new here and am just about to start my firest scratch build and I've jumped in the deep end,

the boat i have picked is the BIO hesperides (ice breaker/Antarctic research ship) and it has a fairly complex hull, as i said i am new to scratch builds so what would be the best method to build the hull?


thanks,  Eddie the idiot
Logged

DickyD

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 9,423
  • www.srcmbc.org.uk
  • Location: Southampton UK
    • SRCMBC
Re: errr... hello and hull help please
« Reply #1 on: October 06, 2009, 06:09:47 pm »
Have a look here at the boats built by Bluebird it might help you.

http://www.modelboatmayhem.co.uk/forum/index.php?board=124.0
Logged
Richard Solent Radio Controlled Model Boat Club http://www.srcmbc.org.uk

eddie the idiot

  • Guest
Re: errr... hello and hull help please
« Reply #2 on: October 06, 2009, 07:32:18 pm »
looks very usefull thanks bit its going to take a while to read......


thanks,  eddie the idiot
Logged

tigertiger

  • Global Moderator
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 7,748
  • Location: Kunming, city of eternal springtime, SW China.
Re: errr... hello and hull help please
« Reply #3 on: October 07, 2009, 02:16:48 am »
Take your time Eddie. It is certaily worth the read.

Lots of good into in those masterclass builds.
Logged
The only stupid question is the one I didn't ask

eddie the idiot

  • Guest
Re: errr... hello and hull help please
« Reply #4 on: October 07, 2009, 07:42:54 pm »
looking at that i think the hesperides may be a bit too much for a fist hull, ive also got a set of plans for the oil challenger i think that may be a better starting point (only one curve on it and thats the bow)


thanks eddie the idiot
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.102 seconds with 22 queries.