Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Suitable hull for steam engine  (Read 1212 times)

AlMacRob

  • Guest
Suitable hull for steam engine
« on: November 20, 2009, 11:36:51 AM »

Hello. I'm new to the forum. I recently bought some plans for the Clyde Puffer "Skylight" by J. Pottinger. The plans show the bread and butter method of building the hull. However I want to build the puffer with a steam engine. What would be the best material to build the hull from? Would it be best to make the hull as on the plans and use this as a mould for a fibreglass hull?
Any advice would be greatly appreciated.
Thank you,
Alasdair.
Logged

gondolier88

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,351
  • www.coniston-regatta.co.uk
  • Location: Crake Valley, Cumbria
    • Coniston Regatta
Re: Suitable hull for steam engine
« Reply #1 on: November 20, 2009, 09:52:30 PM »

I don't know the design myself so I can't advise size-wise, however if you construct it bread and butter the use it for a GRP mould that should be ok.

Greg
Logged
Don't get heated...get steamed up!
Pages: [1]   Go Up