Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: wiring two esc's to a switch  (Read 2058 times)

lozvik

  • Guest
wiring two esc's to a switch
« on: November 22, 2009, 08:37:10 AM »

Is it ok to wire two esc's to one on off switch
Logged

HS93 (RIP)

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,949
  • I cannot spell , tough
  • Location: Rainhill UK
Re: wiring two esc's to a switch
« Reply #1 on: November 22, 2009, 08:47:31 AM »

A bit more info req ,because you normally switch the power supply of to the receiver from the BEC and you only ever have ONE BEC in use at Any one time.so if its your two Mtronics you need to remove one of the red wires from the receiver plug, just get a pin lift the flap and bend back and put a bit of tape on so it can be replaced if needed in the future, it,s safer than just not switching one on.

Peter
Logged

lozvik

  • Guest
Re: wiring two esc's to a switch
« Reply #2 on: November 22, 2009, 09:15:18 AM »

So are u saying join both esc's to a single switch but take off middle wire to rx from one esc?
Logged

HS93 (RIP)

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,949
  • I cannot spell , tough
  • Location: Rainhill UK
Re: wiring two esc's to a switch
« Reply #3 on: November 22, 2009, 09:22:41 AM »

the one you remove the wire from will not req a switch just tape it up in the off position.

Peter
Logged

lozvik

  • Guest
Re: wiring two esc's to a switch
« Reply #4 on: November 22, 2009, 09:35:30 AM »

Ok I'll take yr word for that then, I don't really understand it but as long as I know which wire goes where that'll do for me, lol
Logged

HS93 (RIP)

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,949
  • I cannot spell , tough
  • Location: Rainhill UK
Re: wiring two esc's to a switch
« Reply #5 on: November 22, 2009, 09:37:47 AM »

dont take my word , wait for other post and take your pick. lol


Peter %%
Logged

Timo2

  • Guest
Re: wiring two esc's to a switch
« Reply #6 on: November 22, 2009, 10:48:00 AM »

Hi Lozvik

   To help you understand model boat  wiring go to  The ACTion  web site , and check out the Wiring Diagrams


    Eg.      http://www.action-electronics.co.uk/pdfs/Twin%20Motors.pdf

    Timo2  :-))
Logged
Pages: [1]   Go Up