Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: 34 inch Precedent Fairey Huntsman  (Read 2338 times)

funtimefrankie

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,260
  • Location: Birkdale, Lancashire. twixt the Mersey & the Ribble
34 inch Precedent Fairey Huntsman
« on: November 30, 2009, 01:23:47 PM »

Anyone gone brushless with this model?
(The Glass fibre hull version)

If so what's your set up???
thanks
Frank
Logged

red181

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,736
  • Location: Wirral
Re: 34 inch Precedent Fairey Huntsman
« Reply #1 on: December 07, 2009, 11:45:28 PM »

ive gone brushless with the 4 foot huntsman 28, not quite there yet with final set up, align 1640kv 600l motor, castle creations hydra reversing esc, 1.5:1 gear ratio, 19.2v nimh, yesterday ran with 2 x 9.6v (19.2v) 4600 mimh packs, and 55mm "x" blade prop, after about 15 mins going quite fast, things started to get a bit warm, so think it was a bit over propped.

Recently tried same set up, but with 52.5mm prop, with 6 cell 5000mah lipos, for approx 15 seconds it was absolutely ballistc :embarrassed:, but then a lipo cell died. After doing some research, I am going to drop to 5 cells, and test with smaller prop, just waiting for the 2 cell to arrive, to pair with a 3 cell I have, I think if I try 6 cells again, something will blow up, and paypal is well and truely empty!! :}
Logged

triumphjon

  • Guest
Re: 34 inch Precedent Fairey Huntsman
« Reply #2 on: June 12, 2010, 06:36:19 PM »

i see you have gone the brushless route , im about to start a fairey spear , but im looking at biulding as per origanal  , ie twin shaft twin motors ! with the motors fitted in the correct compartment amidships , how did tour model perform ?
Logged

HS93 (RIP)

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,949
  • I cannot spell , tough
  • Location: Rainhill UK
Re: 34 inch Precedent Fairey Huntsman
« Reply #3 on: June 12, 2010, 11:20:08 PM »


look at

http://www.modelboatmayhem.co.uk/forum/index.php?topic=21584.0

it has the motor in the right place but it is 42"

Peter
Logged
Pages: [1]   Go Up