Hello pals, I have some pictures I just start to build. Micro mahogany classic speed boat. Hull prototype made by foam then framed.
After I start to plank with mahogany veneer strips. I use mini car seats for driver seats. After planking I was dig to foam and empty
inside hull for micro rc car receiver, motors and batteries. I already set shaft, prop and rudder. I will try to set motor receiver and micro
direction unit inside hull. I have to set 2.4 volt mini nimh batteries inside the hull also. This boat size L 14.5 cm ,W 5.0 cm and H 4.0 cm
Regards for everybody. Aydemir