Oops
a bit late now Martin as the hull is well on it's way now , and i dont know what macro is apart from a cash and carry store ,nope thats makro
. Hopefully these will show more.
I have glued both sides together , drawing the bow to a point which is pinned and glued the bottom is then trimmed .
Bulkheads are then fitted to keep the sides straight and the stern made and transum fitted , all the joints after gluing are sealed with bathroom sealant and smoothed out . Thd drive and steering was the next to be fitted and this was simply a hole cut out, a dab of sealant and a couple of short screws to hold everything in place .The servo is heald in with blocks of ply glued to the foam only, i will have to fit an alloy plate over the schottel under slight tension to stop the top cog lifting and slipping .
Rubbing strips are fitted to the bottom just for added protection as this is a foam boat , and a coat of paint applied , this will have to be left a couple of days to dry and soak in .
daz
first panel glued
view of bow section with bulkhead in.
underside of stern showing step where drive will fit.
drive and servo in place .
rear hatch fitted with handle.
bow sealed up and taped .
underside with rubbin strips and shottel drive.
first coat on the bottom