Hi All
If anyone has built one of these perhaps they can answer these questions -
I am ready to install the two servos that fit in the forward part of the main hull that control the forward hydroplanes .It seems to me that once the servo leads are fitted to the RX located in the water tight main frame they will prevent the sub being opened up for charging etc. Does this mean you have to unplug the leads from the RX each time ? and this is assuming there is enough slack in the leads to open this far?
The parts list calls for 2 x 400mm servo extension leads and 1 x 1000mm extension lead but the 400mm leads look to me to be too short to allow for opening as above and I cannot see the purpose of the 1000mm lead.
Any advice will be very welcome.