Help has anyone built htis kit as I am at the moment threatening to take bloomin big hammer to it!!!!Having purchased this part built Tug s/h it was fitted with a kort nozle no motor,deck had been fitted!!!!superstucture poorely built so it was back to teh drawing board.Having fitted a MFA 6;1 motor 12v batt reciever,and servos etc it was time for the bath test,all well and good,had to ballast the stern to get the kort in the water(this is where the problems start)well it was time for proper testing so down to the lake I went,oh bloomin heck water all over the deck far too low in the water!!!!back to the drawing board,plan b change from the 12v batt to 6v change motor remove some rear ballast try again,not enough this time kort out of water,what I anm getting at is when it is ballasted to get the kort in the water as soon as forward motion is started water seems to be very close to the deck level and generally come over.Has anyone else had this problem with this model or is it just me!!!!.If i cant cure it I will remove kort and propshaft and scrap the flippin thing help