Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Trawler project  (Read 2320 times)

STEVO

  • Guest
Trawler project
« on: June 19, 2010, 10:54:09 am »

Just finishing off my Models By Design fishing trawler,but cant find any lobster pots for the deck,would any one know where i could source some from.

Thanks.
Logged

Arizona57

  • Guest
Re: Trawler project
« Reply #1 on: June 19, 2010, 11:05:45 am »

Logged

fatcat123

  • Guest
Re: Trawler project
« Reply #2 on: June 19, 2010, 11:43:43 am »

Hi,

Why not just make some from balsa, cotton bud shaft and a bit of orange string?

Dan


Logged

Guy Bagley

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,218
  • Location: thames valley
Re: Trawler project
« Reply #3 on: June 19, 2010, 04:30:56 pm »

i think george turner does some, in resin......

and have al ook at model dockyard, i remember years ago seeing some in plastic kit form.....
Logged
all in all its just another brick in the wall......

DickyD

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 9,423
  • www.srcmbc.org.uk
  • Location: Southampton UK
    • SRCMBC
Re: Trawler project
« Reply #4 on: June 19, 2010, 05:22:00 pm »

Logged
Richard Solent Radio Controlled Model Boat Club http://www.srcmbc.org.uk

captain ron

  • Guest
Re: Trawler project
« Reply #5 on: June 19, 2010, 10:30:16 pm »

Try Mike Mayhew at Waverley Models he does a good range of 1/12 scale gear.

If he doesn't have it he'll make it and he is reasonable cost wise.

Ron
Logged
Pages: [1]   Go Up
 

Page created in 0.087 seconds with 21 queries.