Now I have fitted all the plywood and the hull has been covered with filler. It has been a bit of a challenge, especially because I cannot get that many things here in Singapore, hence I have had to improvise a bit. But I think that the result at present is quite OK, you can see some of the pictures below.
This was how and made the bow, by bending the plywood. What I did was to let it be in water for approx. 12hours, where after I bended it as per above. It turned out to be quite good, and I think the result of the bow is OK.
This is how it looked after the bended plywood was fitted.
This is after applying the first filler, it would was not the best result but I found a better product which you can see result of below.
The above picture is after the last wood was fitted, used balsa wood to get the best curves at the edge.
This is after the first coat of the new filler was applied, the result is much better.
This is after sanding the first coat of filler, the result is quite nice, but there were some spots which at least need another coat.
I am really satisfied with the result of the stern, the curves are very good.