Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: light cover  (Read 2159 times)

rescue

  • Guest
light cover
« on: February 14, 2007, 08:20:39 am »
I'm building a Mersey lifeboat (1:20) but i have a problem
how to make the light cover which protects the lights

in realty they are around 20cm by 20 cm

example in the right top corner

Logged

White Ensign

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 779
  • Limits must be limited!
  • Location: Stuttgart, Germany
Re: light cover
« Reply #1 on: February 14, 2007, 09:59:00 am »
Edwin, depending on the diameter I use to take the covers which will be used by electricians for the cable-ends. They are very fine and you can easily cut out the hole for the lights. Pull them over the bulb and seal it with a drop of resin- does a perfect job.

Hope this was out of any help, Jörg
Logged
When God created planet earth, he made it with 75% of water. Bet he had the modelboaters on his mind!

rescue

  • Guest
Re: light cover
« Reply #2 on: February 14, 2007, 10:35:37 am »
Quote from: White Ensign on February 14, 2007, 09:59:00 am
Edwin, depending on the diameter I use to take the covers which will be used by electricians for the cable-ends. They are very fine and you can easily cut out the hole for the lights. Pull them over the bulb and seal it with a drop of resin- does a perfect job.

Hope this was out of any help, Jörg

i wil try it

other ideas are stil welkom

edwin
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.111 seconds with 22 queries.