Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Happy Hunter- where to snip?  (Read 1833 times)

Pat Matthews

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 254
  • Get your boats wet!
  • Location: Temecula, Sunny California
    • Matthews Model Marine
Happy Hunter- where to snip?
« on: June 25, 2011, 07:43:46 pm »

I recall running into this on a previous Robbe model... fuzzy definition of the trim line on the vac-formed ABS hull. Where to cut?

On the outside, you can see a wide softly defined line:




And on the inside, the more sharply defined, but still rather wide line:




I suppose I can trim to the top of the interior line, I can always cut more later... but does anyone KNOW the correct place to trim to?

Thx,
PM
Logged
Pat Matthews
Get Your Boats Wet!
Matthews Model Marine

awvs

  • Guest
Re: Happy Hunter- where to snip?
« Reply #1 on: June 26, 2011, 01:11:40 am »

Hi PM,
maybe this picture of my Happy Hunter is helpful.

Regards
Wilhelm
Logged
Pages: [1]   Go Up
 

Page created in 0.15 seconds with 21 queries.