Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Steerable Kort Nozzle/prop alignment  (Read 2418 times)

Netleyned

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 9,051
  • Location: Meridian Line, Mouth of the Humber
    • cleethorpes mba
Steerable Kort Nozzle/prop alignment
« on: August 10, 2011, 10:10:48 am »

I feel sure that I have seen a post explaining the alignment process but I cant seem to find it in search
I assume that I have to fit the nozzle first in alignment with the hull and the use a disc on the shaft.
How far through the nozzle does the disc sit as the inside of the nozzle is tapered
Models by design springer hull and 40mm Kort set are the parts in question

Ned
Logged
Smooth seas never made skilful sailors
Up Spirits  Stand fast the Holy Ghost.
http://www.cleethorpesmba.co.uk/

Timo2

  • Guest
Re: Steerable Kort Nozzle/prop alignment
« Reply #1 on: August 10, 2011, 10:45:43 am »

Hi Netleyned

 Thank you just started to look for details myself ,  O0  but for a twin system to if a scratch pusher tug

  Timo2

 hope for some good reply's

Logged

John W E

  • I see no ships !!
  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 8,813
  • Location: South shields
Re: Steerable Kort Nozzle/prop alignment
« Reply #2 on: August 10, 2011, 11:00:06 am »

Logged
Knowledge begins with respect
But fools hate wisdom and discipline

Netleyned

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 9,051
  • Location: Meridian Line, Mouth of the Humber
    • cleethorpes mba
Re: Steerable Kort Nozzle/prop alignment
« Reply #3 on: August 10, 2011, 11:53:36 am »

Thanks for that John
Two discs to fit the taper will hopefully hold the shaft in the right place
Its a steerable Kort so it will have to be fitted first and immobilised while the shaft is tacked in place

Ned
Logged
Smooth seas never made skilful sailors
Up Spirits  Stand fast the Holy Ghost.
http://www.cleethorpesmba.co.uk/
Pages: [1]   Go Up
 

Page created in 0.094 seconds with 22 queries.