Stern
More SuperStructures
Mr Pooky checking on the build
Aft Hanger
Running Gear
Carrying on from where I am now.....
Bases for the window wipers created out of 1.0mm styrene, cut to 10.8mm long by 1.7mm wide, wiper motor housings cut to 4mm out of 1.5mm Styrene.
Not doing the actual wiper - too thin, unless I get a brain wave.
Still to shape n sand.
Rear S/S behind bridge now sanded down.
Current
Done a bit more to the model, looks like I'm going to have to figure a way of powering the radar, will have to have the shaft going through the bridge though..which is a downer..Any bright ideas, I was planning on putting glass in it?
Love filler!!!
Found a bargain on ebay
Could not pass it up, was blown away by the price. So she may well have sound...
Put it on my blog.
http://pittnuma-type23.blogspot.com/2011/10/bargain-on-ebay.htmlBases for the window wipers created out of 1.0mm styrene, cut to 10.8mm long by 1.7mm wide, wiper motor housings cut to 4mm out of 1.5mm Styrene.
Not doing the actual wiper - too thin, unless I get a brain wave.
Still to shape n sand.
Rear S/S behind bridge now sanded down.
Sanded, edged and glued in place.
Building the forward Mast for the Citadel.
Easier than I thought so far, especially if you use the CAD drawings.
As you can see the mast is built out of 4 sides of styrene, the top mast resin piece is supplied by Fleetscale. Think I will drill out the centre to remove some of the weight, ah, maybe not, I have to get the shaft for the radar motor through that.
Not glued, starting on the base now.