Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: 1 [2]   Go Down

Author Topic: F1 Tunnel 2011 design  (Read 6278 times)

gregk9

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,261
  • Location: West Midlands
    • Chasewater Model Boat Club
Re: F1 Tunnel 2011 design
« Reply #25 on: October 01, 2011, 12:15:19 AM »

Id of much sooner listened to the sound of the brushless motor, than that bit of, er "seedy" music.
After seeing the end of the vid clip, whens Mk2 venturing out?

or did you manage to paddle out and pick up the pieces Daz?
Logged
Best wishes.

Steve. G.
Treasurer & Membership Secretary:  Chasewater Model Boat Club
http://chasewatermbc.blogspot.com/

F1 madness

  • Guest
Re: F1 Tunnel 2011 design
« Reply #26 on: October 01, 2011, 11:22:40 AM »

LOL i know mart,but for 1st attempt not bad.

Hey steve the hulll landed right way up and no damage,hit the throttle and of she went again no probs,just shows how strong my hulls are built it hit the water hard and survived.
As for mk2 not yet anyway,im concentrating on getting this setup,so far shes great but more still to come out if it yet :-))
Logged

F1 madness

  • Guest
Re: F1 Tunnel 2011 design
« Reply #27 on: October 04, 2011, 05:02:12 PM »

Hi guys,just an update
CAD work is almost complete and will soon be able to send of for the 1st lasercut hull :}
I will have to retest but should be fine,once this has been done and tested i can then think about putting this hull into production.
The hulls will be built by myself with fibreglass canopies of 2 or 3 different designs form traditional to modern day styling.
Will keep you updated on progress :-))
Logged
Pages: 1 [2]   Go Up