Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: small couplings  (Read 2849 times)

bbdave

  • Guest
small couplings
« on: November 03, 2011, 09:36:55 pm »

Hi i am looking for some small diameter couplings they're not for a prop shaft i'm sure i've seen some small brass ones somewhere but just can't remember where or who was selling them even a ball dogbone type could do i do need a definate pivot point.

 but they can only be around 7mm O.D.

Dave
Logged

daveorgan

  • Guest
Re: small couplings
« Reply #1 on: November 03, 2011, 09:55:28 pm »

mustang mark sells them  look up marks model boats on net or mustang mark on ebay hope this helps
Logged

MikeA

  • Guest
Re: small couplings
« Reply #2 on: November 03, 2011, 10:00:09 pm »

bbdave if they dont need too much torque use a peice of silicone tube  %%
Logged

bbdave

  • Guest
Re: small couplings
« Reply #3 on: November 04, 2011, 06:19:34 pm »

I have had a look on MMBs site but they seem quite big i may try some tube on a test rig thanks for replies

Dave
Logged

andyn

  • Guest
Re: small couplings
« Reply #4 on: November 04, 2011, 07:12:30 pm »

I have had a look on MMBs site but they seem quite big i may try some tube on a test rig thanks for replies

Dave

Send me a pm with what you need, we can make them whatever size you like :-))
Logged

irishcarguy

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,371
  • Happiness is running from a grizzly and escaping
  • Location: Calgary N. W. Alberta, Canada
    • Britishcars International. org.
Re: small couplings
« Reply #5 on: July 06, 2012, 07:09:57 am »

Try the model car section of your hobby shop, they have some very nice small drive joints.Looking at the date this may be a bit too late, but still O/K for someone else. Mick B.
Logged
Mick B.
Pages: [1]   Go Up
 

Page created in 0.089 seconds with 22 queries.