After some head scratching,and taking onboard the advice given here,I,ve now got power to 2 of the motors,I connected an Rx & Tx that I knew was good, albeit only a 2ch, but i got there, i,ve got 2 working speed controllers, the third which is connected to the centre motor appears to be boogered,But the motor is good as I tested it via battery,therefore, what i,d like to do now, is just use the 2 x speed controllers,working the 3 motors,.. the 2 outside motors,controlled by one speed controller, and the other controlling the centre and rudders,
...What I need to know is,...What wires go where????? for setting up the 2 x motors controlled by 1 x speed controller,
as it stands, the wires from the 3 x motors,are paired off into a block connector,then the blue/yellow from the speed controllers go into their respective terminals i.e blue/yellow, to starboard motor, then to port, and then to centre,..I do understand a little about electrics, and that I will have to move remove the dud speed controller,then take the wires from either port/starboard,motor and fit to centre, which leaves me with 1 x speed controller and 2 x motors,...Now I fall flat on my mush, and scratch my head???...help,