Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: turnigy plush esc 30a  (Read 2413 times)

Mad_Mike

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,596
  • Lincolnshire
  • Location: Lincolnshire
turnigy plush esc 30a
« on: April 17, 2012, 11:15:59 pm »

does anyone know if this esc will start up with the throttle positioned centrally.
http://www.ebay.co.uk/itm/Turnigy-plush-30a-amp-brushless-esc-speed-controller-UK-/130653609834?pt=UK_ToysGames_RadioControlled_JN&hash=item1e6b8fdf6a

Ive used the 30 amp brushed ones and then needed the thottle to be at the lowest point before they would arm, and it meant taking the return spring out of my tx
Logged

CF-FZG

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 230
  • Location: Oxfordshire
Re: turnigy plush esc 30a
« Reply #1 on: April 17, 2012, 11:31:10 pm »

Yes, but you might need to
1. set your ATV to 0 on the down stroke, and
2. move the stick back to 'arm' the esc.

The esc should then recognise 'center stick' =0% and 'full stick' = 100%

If you can set a throttle curve it's even easier :-))


Mark.
Logged
Mark.

Tonka Toys - Big boys toys :)

Mad_Mike

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,596
  • Lincolnshire
  • Location: Lincolnshire
Re: turnigy plush esc 30a
« Reply #2 on: April 18, 2012, 09:20:32 am »

 %% youl have to dumb that down a bit whats the ATV?
Logged

CF-FZG

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 230
  • Location: Oxfordshire
Re: turnigy plush esc 30a
« Reply #3 on: April 18, 2012, 10:43:30 pm »

Adjustable Travel Volume, the ratio, (by percentage), that stick movement transfers into servo movement.


Mark.
Logged
Mark.

Tonka Toys - Big boys toys :)

Paul R

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 97
  • Location: West Midlands
Re: turnigy plush esc 30a
« Reply #4 on: May 13, 2012, 06:08:29 pm »

Hi. The answer to your query is YES. 

1) Switch on your TX, then move the throttle stick to full (top position in other words)

2) Now connect your motor battery and power up your ESC, you will hear two or three short beeps, (this is the ESC confirming you have set full throttle)

3) Now move the throttle stick on your TX down to the middle or neutral position (esc will beep again followed by a number of beeps indicating the number of cells (li-po) you have connected , and thats it. Works well with a Planet 5 TX & RX,

Hope it works with your set-up..

Logged

Mad_Mike

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,596
  • Lincolnshire
  • Location: Lincolnshire
Re: turnigy plush esc 30a
« Reply #5 on: May 14, 2012, 08:27:38 am »

thanks for that :-))
Logged
Pages: [1]   Go Up
 

Page created in 0.121 seconds with 22 queries.