Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: 70ft Canadian power boat launch  (Read 1852 times)

bbdave

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 271
70ft Canadian power boat launch
« on: July 02, 2012, 09:28:44 pm »

Having considered my next project i have decided to visit the loft and resurrect an old project i started this a couple of years ago and for some reason abandoned it maybe due to lack of pictures to work to. I have seen on HSLs site they do a moulded superstructure and fittings at 1:24 don't seem hard to get so fingers crossed this time i'll post pictures to aid completion
as it'll help keep me going. 

The hull so far i think it looks ok i just need to finish the deck with another layer of 1mm ply













Dave
Logged

Norseman

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 3,466
  • Location: Huyton, Liverpool
Re: 70ft Canadian power boat launch
« Reply #1 on: July 03, 2012, 08:26:51 am »

Hi Dave

You're starting this a bit like those Chef programs
Opens the oven and says 'Here's one I made earlier' except you used the loft{-)
Good that you got it down, but have you got a picture of the original / what you're aiming for please?

Dave
Logged

bbdave

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 271
Re: 70ft Canadian power boat launch
« Reply #2 on: July 03, 2012, 03:18:39 pm »

Ha kind of i go through stages where i build then the urge just goes it maybe because i have little space and fetching everything out each evening gets laborious .  it's one of these

http://www.hslmouldings.co.uk/pbm_mgb.htm

Dave
Logged
Pages: [1]   Go Up
 

Page created in 0.105 seconds with 21 queries.