Model Boat Mayhem - Forum

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: WELBRO CARBS  (Read 1694 times)

KIMBO

  • Guest
WELBRO CARBS
« on: May 09, 2006, 12:01:09 PM »

TEETHING PROBLEMS , THESE CAN BE MORE OF A PAIN , THEN GETTING ALL THE WAY TO THE LAKE, AND THEN THINKING WHERE IS MY TRANSMITTER, ANSWER : SAT ON THE BENCH IN THE SHED ON CHARGE. ANYWAY BACK TO THE PROBLEM. THIS BOAT I GOT HAS A WELBRO CARB, WITH TWO NEEDLE VALVES ON THE SIDE, TO SET THEM UP, I WAS TOLD WIND THEM ALL THE WAY IN, THEN 2 AND A QUARTER TURNS OUT, BEEN THERE DONE THAT, ITS OFF LIKE THE CLAPPERS ON THE STAND, WONT PEAK GOING ROUND THE POND, DO YOU THINK THE PROPS COULD BE TO BIG, ITS GOT A MATHE G5 ENGINE IN .  :-\ ??? GIS A CLUE OF A BETTER WAY TO SET UP PLEASE
Logged

RC John

  • Guest
Re: WELBRO CARBS
« Reply #1 on: May 09, 2006, 05:00:19 PM »

See your personal E-mails for some suggestions.
John
Logged

KIMBO

  • Guest
Re: WELBRO CARBS
« Reply #2 on: May 09, 2006, 05:14:07 PM »

i will john thanks
Logged
Pages: [1]   Go Up