Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: 1 2 [3]   Go Down

Author Topic: Revell type V11 convertion  (Read 16844 times)

coolbumble

  • Guest
Re: Revell type V11 convertion
« Reply #50 on: January 03, 2012, 09:45:58 pm »

You can get almost any size seal from bearing and "O" ring suppliers should not be a problem Take a good one with you as a sample.
Even some companies supply on-line
 :-))Ian
Logged

submate

  • Guest
Re: Revell type V11 convertion
« Reply #51 on: January 12, 2012, 10:59:44 am »

Thanks Ian

But unfortunately it was WTC recess that had failed I am still looking into how I can reinforce it >>:-(
Logged

coolbumble

  • Guest
Re: Revell type V11 convertion
« Reply #52 on: January 12, 2012, 06:00:21 pm »

Well I'm sure plenty of folk on here may have different ideas but I would have thought Araldite rapid would do the tick you can shape it when its really gone hard .
Ian :-))
Logged

redboat219

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 52
  • Location: Philippines
Re: Revell type V11 convertion
« Reply #53 on: June 01, 2012, 10:20:24 am »

Any updates on this beautiful build?

May I know who's WTC is it you're using here. Thank you.
Logged
"Better is the enemy of good enough"

redboat219

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 52
  • Location: Philippines
Re: Revell type V11 convertion
« Reply #54 on: August 14, 2012, 04:35:00 am »

Hi, any updates on your Type VIIC?
Logged
"Better is the enemy of good enough"

submate

  • Andy
  • Shipmate
  • *
  • Offline Offline
  • Posts: 1
  • Location: Nuneaton
Re: Revell type V11 convertion
« Reply #55 on: October 06, 2012, 10:47:12 am »

Due to domestic probs I have been unable to continue with my project so far. But, when things settle down I will update you as per.

In answer to the question of who made the WTC. It was Mick at Hinkley Model Boat Club who well into Subs. I can provide a phone no if required.

Thanks for your patience
Logged
Regards

Andy
Pages: 1 2 [3]   Go Up
 

Page created in 0.113 seconds with 22 queries.