Thank you Dave for the kind words. It started life as an axle made by HPI racing but they just did not want to bother with a little guy like me & just brushed me off with my design conversion.I have sent two to England to two friends that I knew would give me an honest opinion warts and all. It is not my intention to produce them for sale, the sole intent was to make something to put that dreaded Huco to shame. Most of you know that the two guys I trusted to test it was Dave Martin ( Norseman) & Dave Milburn ex ACTion guru. However I have gained several good friends on this forum & would be happy to make one for you at dead cost. One axle is $20.00 (two in a packet, $40.00 ) & posting was $10.00, total $30.00 or about 20 pounds each. Tony & Essex I have you on my list & will make one for each of you, but I require measurements as each is custom made to fit your motor & shaft. We can talk later through PM. A final note if you want to make your own it is not hard but you do need the best drills,taps & dies. PM me for details. Mick B.