Hi, all.
I am pretty new to this. the building side of things,fine , :) but when it comes to the things that make it go, why are the wires all different colours, ???, Well perhaps I`m not quite that bad.
My problem started when someone offered me a 50" motor cabin cruiser that needed restoration, Old and dusty with only the props and rudders left in.
I took up the challenge ( how hard can it be) and I`m doing fine,it is starting to look good. Now I need to think more of how it will move.
I have so far got an acoms 2 ch transmitter, 2 servos, rx with battery box, and 2 marbuchi RS540SH motors. Also while I was in singapore on the way back from Indonesia, I happened across a place brimming with R/C models and equip, and without too much thought, bought 2 Esc`s rated max 100amp for and 50amp reverse.
Now guy`s what do I do with all this and what else do I need( Cos just chucking them all in the boat does`nt seem to work)
I don`t know if all of these will match up and what wire goes where,
Any help would be much appreciated