Right got a few problems with my springer, the ESC popped, replaced with a perkins marine, issue I now have is that I cannot get the RX to work properly. I keep getting a green light then a red light, the rudder servo keeps fitting and the motor runs slow and then stops. Cannot get the TX to do much at all. The AA batteries are all okay and charged, the two 12v lead batteries have been left to charge but not sure if they are. Have ordered a new 6v-12v charger as I noticed the old charger had a frayed wire, but just wondered if there is not enough juice in the batteries would this cause all the issues or has the RX, servo etc blown too?
I also have bought two waterproof inline fuse cases, where do I place these, is it between the positive on the motor and the ESC, or motor and the battery? One Fuse case per boat I may add. Also what rated fuse should I fit? These will take up to 30a I was thinking a 10a.
Any help appriciated guys.
Si:)