Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: ESC to reciever.  (Read 2779 times)

tugboattam

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 73
  • Model Boat Mayhem is Great!
  • Location: Kinghorn, Fife, Scotland.
ESC to reciever.
« on: May 08, 2013, 09:02:11 am »

Hi all,  Is there any particular slot in the reciever that the lead from the ESC should be plugged into or does it not matter ?  Ian.
Logged

Stavros

  • Guest
Re: ESC to reciever.
« Reply #1 on: May 08, 2013, 09:08:28 am »

Pin 2 on 2 channel set  3 on 4channel this is usually the case


Dave
Logged

Netleyned

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 9,051
  • Location: Meridian Line, Mouth of the Humber
    • cleethorpes mba
Re: ESC to reciever.
« Reply #2 on: May 08, 2013, 09:11:47 am »

Normally marked Throttle
Usually pin set 2 or 3



Ned
Logged
Smooth seas never made skilful sailors
Up Spirits  Stand fast the Holy Ghost.
http://www.cleethorpesmba.co.uk/

hmsantrim

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 733
  • Location: U K
Re: ESC to reciever.
« Reply #3 on: May 08, 2013, 01:08:48 pm »

 
 Hi Ian.
 
    I will assume you are using a 2channel set for the seaport refurb.   Below the sticks on the transmitter they are numbered
    (1) right hand stick (2) left hand stick.  You will note the right hand stick (1) moves left -right this is the stick for the rudder and corresponds to hole no1 on the receiver for the rudder servo.    The left hand stick (2) moves forward-reverse this is the stick for the speed controller and corresponds to hole no (2) on the receiver. 
 
    There is also a slider switch next to each stick this is a trim switch and is used to centre the the speed controller or the servo arm on the rudder servo. 
 
         frank.
Logged

tugboattam

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 73
  • Model Boat Mayhem is Great!
  • Location: Kinghorn, Fife, Scotland.
Re: ESC to reciever.
« Reply #4 on: May 08, 2013, 06:28:48 pm »

Thanks for the replies, thats another problem sorted but Im sure there will be more !!   Ian.
Logged
Pages: [1]   Go Up
 

Page created in 0.087 seconds with 22 queries.