Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Turnigy aquastar 120a esc  (Read 1064 times)


  • Shipmate
  • *
  • Offline Offline
  • Posts: 21
  • Model Boat Mayhem is Great!
  • Location: uk
Turnigy aquastar 120a esc
« on: June 03, 2013, 07:25:55 PM »

Hi I've just purchase the esc it is going into a miss geico pro boat with a 1500kv motor with turnigy 2x3s 40c lipos and a octura x642 prop will this setup work ok?

Could anyone also advise how I will need to have this programmed with the esc program card?

Thanks in advance.


  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,597
  • Lincolnshire
  • Location: Lincolnshire
Re: Turnigy aquastar 120a esc
« Reply #1 on: June 04, 2013, 09:36:18 PM »

ESC's like this usually have destructions with them. If not they can be found here:
From looking at the setting you cannot from what i see select 6 cell lipos. You have to auto calculate which in my oppinion is not good as unless the the lipos are fully charged the auto calculate may count the cells wrong and cut off to low after cell damage occurs. It has good reviews though so cant be too bad


  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 6,134
  • Location: Finland, England, Finland!
Re: Turnigy aquastar 120a esc
« Reply #2 on: June 04, 2013, 11:21:57 PM »

I would say spend a couple of quid on a pair of lipo alarms, go belt and braces as it were..... certainly cheaper than new batteries
One By One The Penguins Steal My Sanity
Proud member of the OAM  (Order of the Armchair Modeller)
Junior member of the OGG  (Order of the Grumpy Git)
Pages: [1]   Go Up