Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: A B and C rigs  (Read 1539 times)

g4yvm

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 116
A B and C rigs
« on: August 22, 2013, 10:25:20 am »

I appreciate that a yacht has a variety of sails in her lockers, nominal numbers 0 through to the depth of the owners pocket, BUT, on model yachts (esp the Dragon Im buying) we seem to have A B and C rigs.


Looking at the pictures the rigs seem to fall, from A to C, in aspect ratio.  I assume, but cant tell, that the area of canvas also falls so that she sails in stronger wind.


Firstly, is this true?


Secondly, why the change in rig? Why not simply hank on a smaller sail (like reefing or hanking on storm sails). 


I see the different rigs on the Dragons arent terribly expensive, but I cant see the point either. when one could simply cut new sails (esp as they are flat sails).


David
Logged

john44

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,659
  • member of the Potteries Model boat club
Re: A B and C rigs
« Reply #1 on: August 22, 2013, 01:21:06 pm »

Hi David, you are correct in thinking the sails reduce in size dependent on the
prevailing wind speed.On my IOM I have No,s 1,2 & 3 sail sets No 1 being the largest
It would not be practical and very time consuming to ( hank on a smaller sail)
as the sail setting are totally different, an the smaller sets the mast,booms,spreaders
are smaller the sail are set differently, etc,etc, so it is much easier and quicker
to change the complete sail especially during competition if the wind picks up.

hope this helps

john
Logged

g4yvm

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 116
Re: A B and C rigs
« Reply #2 on: August 22, 2013, 01:36:11 pm »

Thanks John. That makes sense!

D
Logged
Pages: [1]   Go Up
 

Page created in 0.094 seconds with 21 queries.