Well Glenn, I have a bracket and kind of alloy bolt which goes through said bracket that the cable fits in, the inner cable then connects to the carb with a collet and small grub screw, only trouble is that I over tightend the alloy bolt and it snapped, no problem will make a new one. Could not live with that radio box being so close to the pipe so ripped it all out again ! looked at it for hours, then it came to me, flip the bracket it sits on round, this moves the whole box over about 20mm, then drill another hole in the transom, (as if there aint enough allready) on the other side for the push rod, turn bellcrank around and its sorted. This has taken me most of the day, now all I need to do is solder the drive cable, given up on this as I can not find my plumbers flux, tried to use silver solder but you have to get it too hot, hopfully I have not ruined it and my mate at work will be able to sweat the end on for me. What do you guys use ???
Biscuit