Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: [1]   Go Down

Author Topic: Servo Ouput Shaft  (Read 2190 times)

BarryM

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,701
  • Location: West Lothian
Servo Ouput Shaft
« on: May 21, 2014, 10:47:07 pm »

I have been searching for a UK source of an extension output shaft which will fit the splines of a Futaba servo.  I've located some which will fit other servo types but none for Futaba. Before I crank up the lathe, can anyone else come up with a source?

Barry M
Logged

malcolmfrary

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 6,027
  • Location: Blackpool, Lancs, UK
Re: Servo Ouput Shaft
« Reply #1 on: May 22, 2014, 09:18:51 am »

Logged
"With the right tool, you can break anything" - Garfield

BarryM

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,701
  • Location: West Lothian
Re: Servo Ouput Shaft
« Reply #2 on: May 22, 2014, 12:24:41 pm »

Malcolm,
Just that sort of thing but priced in £ and closer to home!

Regards,

Barry M
Logged

malcolmfrary

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 6,027
  • Location: Blackpool, Lancs, UK
Re: Servo Ouput Shaft
« Reply #3 on: May 22, 2014, 05:12:48 pm »

http://www.robotshop.com/eu/en/servocity-shaft-coupler-fsa-250.html
A bit closer, in Euros.  So well hidden in the site that you might be forgiven for thinking that they don't want to sell them.
Logged
"With the right tool, you can break anything" - Garfield

BarryM

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,701
  • Location: West Lothian
Re: Servo Ouput Shaft
« Reply #4 on: May 22, 2014, 07:00:07 pm »

Malcolm,
Just what the doctor ordered! Thank you very much.
Regards,
Barry M
Logged

BarryM

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 1,701
  • Location: West Lothian
Re: Servo Ouput Shaft
« Reply #5 on: May 25, 2014, 11:51:31 am »

Since responding above, I've had the chance to further research the goodies on offer on this website and found some really fascinating stuff. Thanks again Malcolm, I've found more than one solution there.  :-)) The only drawback is the high P&P from France.

Regards,
Barry M
Logged
Pages: [1]   Go Up
 

Page created in 0.096 seconds with 22 queries.