Tested...failed. Miserably...
I tried it (without the esc) on an 11.1v LiPo...shouldn't have done that. The motor was mounted in one of MMB's SubSonic mounts, glued into the wtc end cap. I touched the battery leads to the motor...the prop shot off the shaft, the shaft came out of the motor mount and is currently under the bed somewhere where it finished up, the resin motor mount disintegrated into a million pieces and the motor, now not being fixed to anything, went off along my bench at supersonic speeds, only stopping when the leads to the battery parted company with it.
The whole sorry episode took less than two seconds, but I've never seen so much destruction take place in so short a time...
Oh well...back to the drawing board, as we idiots say. Regularly...
Rich