Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length.

[Dave Cook]

Hi All , A friend of mine as bought a brand new JJC Electronics sound slave card off Flee Bay . How ever once we read the instructions it was clear that a JJC Electronics Master Unit was required to run the slave card . JJC are no longer tradeing so thats not possible . I have since heard that the Master Unit was just a amplifier that could take up to 3 slave cards . Does anyone know of these sound units and of a amp that would do the job and how to wire it up .
The full name on the slave card is V8 Turbo slave card ( sounds amazing) it as a 3.5mm jack socket for out put and a lead for the receiver.
Best Regards Dave 

[Umi_Ryuzuki]

See if you can use some jumper cables to connect the module to some amplified computer speakers.
If that works, you may be able to find a small amp module on Maplins, or maybe
just pull the board from a set of computer speakers and use that.


 

[Stan]

HI Dave first of all a pm sent to you. The master unit was it self a sound unit with a built in amp other slave units could be plugged in to it via a cable. The sounds from the slave all came back to the master unit. JJC made a master amplifier for slave units I have two of these and they are very poor to say the least.  The power for the slave units was taken from the master unit via a cable  if you check you will see on the slave only a rx cable. give me a call and will explain in more detail.

Stan

[timgarrod]

Hi, I friend of mine asked me the same question on the weekend, as has two slave unit like above.

Thanks.