Model Boat Mayhem

Please login or register.

Login with username, password and session length.
Pages: 1 [2]   Go Down

Author Topic: Twin Props Fitting "A" Frames How?  (Read 9696 times)

banjo

  • Guest
Re: Twin Props Fitting "A" Frames How?
« Reply #25 on: December 19, 2007, 12:16:41 pm »

Here we are with a pic of the brass distance strips in place,   This should keep the shafts parallell

 O0
Logged

HS93 (RIP)

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,922
  • I cannot spell , tough
  • Location: Rainhill UK
Re: Twin Props Fitting "A" Frames How?
« Reply #26 on: December 19, 2007, 12:28:37 pm »

Bet your glad you decided to go for twin set up.   :D


Have you joined

http://groups.yahoo.com/group/firefloat/



Peter


Logged

banjo

  • Guest
Re: Twin Props Fitting "A" Frames How?
« Reply #27 on: December 19, 2007, 12:45:02 pm »

OVERJOYED!!!!!!!!!!
 O0
Logged

banjo

  • Guest
Re: Twin Props Fitting "A" Frames Like this?
« Reply #28 on: December 21, 2007, 08:37:38 am »

where I am so far:-

Utilizing all of the above hints and tips I have installed the prop shafts and A Frames.

The legs of the frames were secured inside the hull using sections of tube pushed down over the legs and then epoxied into place using "Z-Poxy"
I would have drilled and pinned them but the appropriate drill suddenly went blunt!!  The tube sections were a desperate alternative which has worked as well. (I hope)

Thanks to all,

 O0

PS
The "E-poxy" is taking a long time to cure, where it is in a "lump" over the "A" Frame fixing?
Logged

HS93 (RIP)

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 2,922
  • I cannot spell , tough
  • Location: Rainhill UK
Re: Twin Props Fitting "A" Frames How?
« Reply #29 on: December 21, 2007, 09:28:03 am »

  See it wasn't that hard.!!! :D   >>:-(  ;)

Peter  :angel:

Looks good by the way
Logged

banjo

  • Guest
Re: Twin Props Fitting "A" Frames How?
« Reply #30 on: December 21, 2007, 09:37:04 am »

Thanks to all the help, it wasn't.....

Its all in the planning...

Get that right and your 85% there..

 O0
Logged

spongie

  • Full Mayhemer
  • *****
  • Offline Offline
  • Posts: 140
Re: Twin Props Fitting "A" Frames How?
« Reply #31 on: August 10, 2015, 09:49:23 am »

Dragging an old topic back from the dead...

I'm about to do this for the first time ever. SERIOUSLY hugely helpful posts folks


Thanks
Logged
Pages: 1 [2]   Go Up
 

Page created in 0.104 seconds with 22 queries.